Troubleshooting
10-3
10
Printouts are too dark. Is the machine in Auto
Density mode?
Set the correct density level for
auto density.
—
Is the machine in Manual
Density mode?
Use [Image Quality] to set the
correct density level.
3-9
When changing the default density
level, adjust the density manually
and choose the desired level.
—
Copies have a moire
pattern (dots grouped
together in patterns
and not aligned
uniformly).
Is the original a printed
photograph?
Set the image quality to [Print
Photo].
3-9
Printouts are not
clear.
Did you choose appropriate
image quality for the original?
Select appropriate image quality. 9-2
Printouts are dirty. Is the platen or the document
processor dirty?
Clean the platen or the document
processor.
9-2
Is the transfer roller dirty? Brush the transfer roller clean. 9-6
Is the drum dirty? Carry out Drum Refresh. 8-45
Carry out Developer Refresh. 8-53
Is the scanner dirty? Carry out Laser Scanner Cleaning. 8-53
Is the Printed Document
Guard Kit enabled?
Disable the Printed Document
Guard Kit.
Appendix-
6
Printouts are fuzzy. Is the machine being used in
very humid conditions?
Carry out Drum Refresh. 8-45
Images are skewed. Are the originals placed
correctly?
When placing originals on the
platen, align them with the original
size indicator plates.
2-34
When placing originals in the
optional document processor, align
the original width guides securely
before placing the originals.
2-34
Is the paper loaded
correctly?
Check the position of the paper
width guides.
2-35
Symptom Checkpoints Corrective Actions
Reference
Page
To Next Page
Loading...
Need help?
General
