Configuration and Programming
P/N 06-237041-001 3-13 February 2011
8 EOC Program. Purpose: To view the Event-Output-Control (EOC) part of the system
configuration file.
9 SLC Assignments. Purpose: To view the registered devices on the SLC.
Figure 3-15. FenwalNET 8000-ML List Menu Functions (Cont’d - Fig. 3 of 4)
FOOTNOTES (Figure 3-15):
10 Line Voltage. List a Range of SLC Device Voltages. Purpose: To view the SLC line voltages for
a range of initiating and/or control devices.
11 9 Volts. List a Range of SLC Devices’ 9-Volt Levels. Purpose: To view the internal power-
supply voltages for a range of SLC initiating and/or control devices.
2. LIST
Cont’d
SLC Module Selection
Enter SLC Module Number (1-8):_*
6. Voltages
1. Line Voltage
2. 9 Volts
3. Battery Charge
SLC Module Selection
Enter SLC Module Number (1-8):_*
4. Gnd Fault Offset
Ground Fault Offset Voltage
Enter Module Logical Address __
7. List Versions
1. Main CPU
3. SLC and Backplane
4. Control Modules
10
11
12
13
BATTERY VOLTAGE AND CURRENT
Battery Data
OCBV:__.__ BCC:_.__ BCV:__.__
Main CPU App Version:_._._
Main CPU Boot Version:___.__
1. RNAC
Enter Logical Address Range: *__to__
2. Relay
Enter Logical Address Range: *__to__
3. City Tie
4. PMU
Enter Logical Address Range: *__to__
5. SLC
City-Tie App Version:____
City-Tie Boot Version:____
1. Main Display
2. RDCM
3. LAM
Enter Logical Address Range:*__to__
Enter Logical Address Range:*__to__
14
Main Display App Version:____
Main Display Boot Version:____
2. CPC
CPC App Version:_._._
CPC Boot Version:___.__
To Next Page
Loading...