multiMATIC 700/2
Notes
10/2015 47 Training 0020228700_00
The controller switches off the zone for 30 minutes and the frost protection function
is activated.
The operating mode that was previously set is reactivated once this time has
elapsed.
Hot water generation and the circulation pump remain on.
The "Party" function can be used in order to avoid having to change the settings on the
controller for short periods of time (extending the heating times).
The controlling behaviour is as follows:
The controller sets the target room temperature to the "Day temperature" that has
been set.
The desired temperature can be changed using the rotary knob. This change will be
applied permanently as the "Desired day temperature".
Hot water generation and circulation are switched on.
The function will be deactivated after 6 hours or after it has been cancelled. The
heating installation will then go back to working in the operating mode that was pre-
viously set.
The "Party" function can be activated from any operating mode.
This is where the cooling function can be activated for a specific number of days.
The desired temperature can be changed using the rotary knob.
The operating mode that was previously set is reactivated once this number of days
has passed.
Heats the domestic hot water cylinder once. If hot water generation is switched off or
hot water is required outside of a time period, the "Cylinder boost" function quickly
heats the water in the domestic hot water cylinder to the target value that has been set.
To Next Page
Loading...
