multiMATIC 700/2
Notes
10/2015 62 Training 0020228700_00
4.5.7.1 System
If "Fault list" is displayed, the warning can be
found using the "Display" button.
Displays the current heating water pressure.
Standby, Heat. mode,
Cooling, DHW
Shows the current operating mode
Delays switching on heating mode; relevant
in Automatic mode with "Eco" or "Set-back"
energy-saving options
Boiler, VR 70, VR 91
Adr.1, heat pump, …
Shows the components identified at the
eBUS and their software versions
All, Zone1, Zone2,
Zone3
*1
Selects which zone the "Operating mode"
button on the basic display has an effect on
Only in conjunction with geoTHERM 3 kW,
aroTHERM and flexoTHERM
Display only for wall-mounted controllers
Displayed only if "Cooling possible" =
"Yes", "Room temp. mod." = "Temp.
mod." and "Zone assignment" = "VRC
700" or "VR 91" selected
Only in conjunction with geoTHERM 3 kW,
aroTHERM and flexoTHERM
Bivalence point: Parallel operation with an
additional heat generator is enabled below
the temperature set here.
Alternative point: The heat pump is
switched off below the temperature set here.
Condens., Non cond.,
Electric
HP off, BH off, HP&BH
off, Heating off, Cooling
off, Heat./Cool. off
Inactive, Heating, DHW,
DHW+heat.
Only with system diagram 6 - 13
The parameters shown in bold in the first column of the table are adjustable.
*1
: Two zones with VR 70 = 1, 5 / three zones with VR 71