Go back to top Go back to ToC
4.5 LEDs
The TX130M+ is equipped with the following LEDs:
Power LED: A single LED indicates the power state of the unit.
The LED is off when the unit is powered off.
The LED is green when the unit is powered on.
The LED is orange when the unit is connected to the AC Main and powered off.
Signal LED: Indicates presence of a valid input signal.
Alarm / Error LED: Indicates the presence of alarms or errors.
Green LED: Indicates that no alarm/error has occurred
Red LED: Indicates that at least one alarm/error has occurred during the test
Red flashing LED: Indicates any alarms/errors that have occurred
Grey LED: Indicates that no condition or a test that has not begun yet
Note:
The Signal and Alarm/Error lights are separated according to whether the Signal or Error/Alarm refers to Ethernet (ETH) or
PDH testing.
Each LED is equipped with a History function.
The History key on the rubber keypad (
key on the rubber keypad (
) resets the soft LEDs on the GUI.
Go back to top Go back to ToC
4.6 Software Upgrade
There are two methods of updating the test set software: manually or via ReVeal MTX software.
Manual Software Upgrade
To manually upgrade the test set software, download the latest version from the VeEX website.
TX130M+_e-manual_D07-00-051P_RevD00
To Next Page
