VeEX VePal TX130M+

To Next Page

To Previous Page

Please refer to 7.4 Upgrade section in the ReVeal MTX manual.

Go back to top Go back to ToC

TX130M+_e-manual_D07-00-051P_RevD00

Main Page

Default Chapter2
- Table of Contents2
1 About this Guide9
2 Introduction to TX130M10
3 Safety Information11
4 Basic Operations12
- Keypad12
- Touch-Screen Display13
- Battery13
- Connectors and Panels13
- Leds15
- Software Upgrade15
5 Home Menus18
- Ethernet and Pdh/Dsn Home Menus18
- Action Menu (Menu B Only)18
6 Menu a - Ethernet/Synce/1588V2/Common Features Setup20
- Port Setup20
- Port Status21
- Laser Activation21
- Profiles22
- Measurement Settings22
7 Bert25
- BERT Setup27
8 RFC 2544 Conformance Testing42
- RFC 2544 Setup42
- RFC 2544 Results51
9 Throughput Testing (Multiple Streams)56
- Setup56
- Throughput Results61
10 OAM Testing70
- OAM Setup70
  - Link Level 802.3Ah OAM Setup70
  - Service Level OAM72
- OAM Results73
  - Link OAM Results73
  - OAM Service Results75
- Definitions78
11 Loopback84
12 Synce85
- Synce Setup85
  - Port (Test Port Selection)85
  - Mode (Synce Test Mode)86
- Clock Measurement88
- Synce Wander Measurements89
  - Setup89
  - Results89
- Esmc Ssm90
1588 V2/Ptp95
- Setup95
  - Mode (Test Mode)96
- Test Results98
- Protocol Monitor101
- 1588V2 Wander Measurements101
  - Setup101
  - Results102
14 Additional Tests - Menu a103
- Netwiz103
- Bert103
- Scan103
- Profile Scripting103
15 Common Functions106
- Additional Tests (Net Wiz)106
- Settings106
- Files106
- Help106
- Backlight106
- Tools106
16 V-Sam107
- V-SAM Setup109
- Results112
17 VLAN Scan116
18 0 Menu B - Pdh/Dsn Setup120
- Signal Overview120
- Measurement Configuration125
- Auto-Config127
19 Results129
- PDH Results129
20 Alarms/Errors137
- Alarm Generation137
21 E1/E3 Tools139
- E1/E3 Pulse Mask139
- E1 APS Testing140
- E1 Frame Words141
- Round Trip Delay141
- E1 Rx Data142
- E1 Vf142
- Jitter Measurement143
  - Setup143
  - Results143
- V.54145
22 DS1/3 Tools146
- DS1 Pulse Mask146
- DS1 Loop147
- Round Trip Delay148
- DS1 Rx Data148
- DS3 Pulse Mask148
- Ds3 Feac149
- Ds1 Vf150
- Jitter Measurement151
23 Profiles153
24 Additional Tests154
- ISDN PRI Call154
- ISDN PRI Monitor162
- WAN IP Test162
- Reference Clock Wander Analysis163
  - Setup163
  - Results164
- 1PPS Phase Analysis164
  - Setup165
25 MTIE and TDEV Analysis167
- Install the MTIE / TDEV Post Analysis Software167
- Move TIE Data to a PC167
- View Data167
- MTIE & TDEV Masks168
- Wander Analysis Report170
26 Warranty and Software172
27 Product Specification173
28 Certification and Declaration174
29 About Veex175
- Go Back to Toc175

VeEX VePal TX130M+ - Page 17

Table of Contents

Related product manuals