Layer 2: Framed BERT (same as Layer 1 Framed)
MAC Address: A default or user configured Media Access Control (MAC) address is added to the frame. This MAC
address is used as the source MAC address for all streams (Throughput Testing mode).
BERT Setup - Header (Layer 2) BERT Setup - MAC address editing
Layer 3: Framed BERT (same as Layer 1 & 2 Framed)
MAC Address: A default or user configured Media Access Control (MAC) address is added to the frame. This MAC
address is used as the source MAC address for all streams.
IP Address: A default or user configured IP address is added to the frame. This IP address is used as the source
IP address for all streams.
BERT Setup - Header (Layer 3)
Layer 4: Framed BERT (same as Layer 1, 2 & 3 Framed)
MAC Address: A default or user configured Media Access Control (MAC) address is added to the frame. This MAC
address is used as the source MAC address for all streams.
IP Address: A default or user configured IP address is added to the frame. This IP address is used as the source
IP address for all streams.
UDP/TCP: A user defined source and destination port address is added to the frame.
TX130M+_e-manual_D07-00-051P_RevD00
To Next Page
