VI.BE.MAC.S.p.A.
pag.14
13. OPERATING SYSTEM
The machine can perform the 7 different types of operation.
These are:
N° TYPE OPERATION
1 DESIGN The operator lowers the blocking jig and presses the button
NORMAL for the start of the sewing cycle.
+ LOADER The operator closes the loading pincer and pushes the loader start button.
The loader positions the pocket under the blocking jig
which lowers automatically and returns to its standby position
2 LABEL The operator lowers the external and internal jig (high internal
NORMAL position) and the sewing cycle is started manually.
Reading the FUN1 code the jig raises, retracts and lowers.
3 LABEL The operator lowers the external and internal jig (high internal
AUTOMATIC 1 position) and the sewing cycle is started automatically.
Reading the FUN1 code the jig raises, retracts and lowers.
4 LABEL The operator lowers the external and internal jig (high internal
AUTOMATIC 2 position) and the sewing cycle is started automatically.
Reading the FUN1 code the jig raises, retracts and stops in its high position
5 NORMAL The operator commands the blocking jig with the Black pedal and
DESIGN commands the start of the sewing cycle with the grey pedal.
6 – 7 DO NOT USE
13.1.FUNCTIONING SYSTEM SELECTION
On the command console fixed to the card cabinet under the Loader:
Press the F key
The following appears on the display:
F U N C
Press the two arrows together (HIGH + LOW)
The following appears on the display:
P - P (P mode)
Hold the two arrows down until the writing changes to:
S Y S w R (WRITING SYSTEM)
- Not used -
Press the arrow once
The following appears:
P R M b .... (PROGRAMMING basic METHOD)
A number appears, in place of ....
Select the required type of function.
Press the D key until the corresponding number appears on the display.
(The number changes from 1 through to 7, then returns to 1.)
Press the H key to exit.
To Next Page
Loading...