VI.BE.MAC.S.p.A.
pag.7
4. MACHINE START-UP
Proceed as follows:
Check the position:
- of the Handwheel, placing its reference point parallel with the reference marker on the case.
- of the Fitting, with the hole in the stainless steel plate placed above the hole of the Needle Plate.
- of the Loading Carriage, placed all the way to the right in the version with this device.
If the Handwheel, the fitting or the Carriage is out of position, move it manually to its correct position.
Introduce current by pressing the ON button on the main current switch.
When the computer has performed the check-up operation:
The following appears on the screen:
PRESS FOOT
Lower the jigs by pressing the relevant buttons
Press the HOME key
The machine searches for the two positioning sensors.
When the machine reads the positioning sensors it finds the Original Point.
The jigs rise and the machine is ready for operation with the programme last used already in the memory.
5. STOPPING THE MACHINE
Press the EMERGENCY button and stop the current by pressing the OFF button on the main current switch
only when the machine has stopped.
The compressed air is automatically turned off.
ATTENTION
In the event of an electricity BLACKOUT, the sewing machine stops through inertia, the Loader unit remains
in its resting position and the loading cycle, if running, is cancelled.
6. CALLING UP A PROGRAMME
Press the READ key
The following appears on the display:
READ DATA
1.MEMORY 2.FD
Select the drive from which the programme should be read
Press the 1 key for the internal memory
Press the 2 key for the Floppy Disk
Confirm the setting with ENTER
The following appears on the display:
1.PATT.No. INPUT
2.PATT.No.SEARCH
Press the 1 key and ENTER
Insert the programme number
Press ENTER
To Next Page
Loading...