Vi.Be.Mac V3L - LIST of MESSAGES (M - XX)

VI.BE.MAC.S.p.A.
pag.16
14.2. LIST OF MESSAGES (M - xx)
After checking for the cause of the Message, press the ENTER key to return to normal operation
M-01 Floppy Disk not inserted Check that the Disk is properly inserted
System Software damaged Reload the System Software from the special disk
(available, on request, from VI.BE.MAC.)
M - 02 Floppy Disk protected Move the protection selector on the Floppy Disk
Use another Floppy Disk
M - 03 Floppy Disk damaged Use another Floppy Disk
M - 04 Lack of free memory Use another Floppy Disk
on Floppy Disk
M - 05 Programme N°. called up Check that the number inserted is correct and make the
from Floppy Disk not correct Floppy Disk read again
M - 08 Not at Departure Point The writing function is not allowed, NOT in its Original
Position. Press the RESET HOME key
M - 09 Not at Departure Point The writing function is not allowed, NOT in its Original
Position. Press the RESET HOME key
M - 10 Writing into Internal Memory The writing function is not allowed. Enable the
not allowed PFL function using the control panel
M - 1 1 Error in Internal Memory Press the ENTER
key. Repeat the operation.
If the message occurs again copy the content of the
Internal memory onto a Floppy Disk and reformat the
Internal Memory with the appropriate function
M - 12 Lack of free memory Cancel unused programmes from the Internal Memory
on the Internal Memory or change the partition (>47 programmes)
M - 13 Programme N°. called up Check that the number inserted is correct and make the
from Internal Memory Internal Memory read again
not correct
M - 16 Internal Memory Partition Insert the correct partition number of the Internal Memory
Number is not correct
M - 20 Machine not in UP position Turn the handwheel by hand until the reference
point on the casing is inline with the reference point
on the handwheel
M - 21 Needle thread broken Check that the threading of the machine is correct
Press the ENTER key
M - 22 Programme outside maximum Check the dimensions of the programme
sewing range Check that the ALC function is ON (P-A)
M - 23 Lower the pressure foot Press the relative switch to lower the Jigs
M - 24 Production Counter The machine has reached the programmed number
UP COUNTER Press ENTER to reset the counter
M - 25 Internal Memory empty There are no programmes saved in Internal Memory
Press ENTER and then call up a programme from
the Floppy Disk
M - 26 Not at Departure Point Press the HOME key