Vi.Be.Mac V3L - Re-Programming the Second Seam in an Embroidery

VI.BE.MAC.S.p.A.
pag.35
22.3.RE-PROGRAMMING THE SECOND SEAM INTO AN EMBROIDERY
Lower the plates
Press the PEN IN key
The display changes to:
DO YOU CLEAR 1Y
RAM 2N
Press 2 and ENTER
The display changes to:
PRESS HOME KEY
Press the HOME key
The machine resets to the ORIGINAL POINT
Press ENTER
Press the JOG+ and JOG- keys together
Insert the number 800 and press ENTER
Press 1 and ENTER
Press JOG+ and ENTER together
The machine automatically shifts to the last stitch.
Press the STITCH CLEAR key to cancel, one stitch at a time, the entire SECOND seam up to point 1 of the
design
ATTENTION: Be sure to cancel the TRIM code (Thread trimming). When the TRIM code (Thread trimming)
appears on the display press the STITCH CLEAR key once
Press SPEED
The display changes to:
SPEED HIGH
ST.LENGTH 3.0mm
With the SPEED key select the type of speed required from the 4 possible, normally HIGH
With the numerical keys set the required stitch length
E.g. 2.5mm insert 2 and 5
3.1mm insert 3 and 1
Press ENTER
Check the type of seam required at the beginning of each tract (STRAIGHT – ARC – CIRCLE –
IRREGULARE CURVES):
STRAIGHT SEAM
Press the TEACHING METHOD key and select the P-P method in the upper right of the display
Move with the directional arrows to the end of the seam
Press ENTER
x
x
CURVE SEAM
Press the TEACHING METHOD key and select the A P1 method in the upper right of the display
Move with the directional arrows to the CENTER of the arc.
Press ENTER
Move with the directional arrows to the END of the arc.
Press ENTER
The display changes to:
A
P1