VI.BE.MAC.S.p.A.
pag.50
23.8.RE-PROGRAMMING THE SEAM OF A STRAIGHT SIDE
Lower the plates
Press the MODIFY key
The display changes to:
PRESS HOME KEY
Press the HOME key
The machine resets to its ORIGINAL POINT
Press the FUNCTION key
The display changes to:
CHANGE RETURN 1Y
FEED 2N
Press the 1 key and ENTER
The display changes to:
1 STITCH 2 SPEED 3 CODE 4MOVE (B)
Press 1 and ENTER
The display changes to:
1 BLOCK 2 FEED 3 DEL 4ADD 5MOD
Press 1 and ENTER to select BLOCK
The display changes to:
START POINT JOG
Use JOG+ to go to the start of the modification (point A)
Press ENTER
The display changes to:
END POINT JOG
Use JOG+ to go to the end of the modification (point B)
Press ENTER
The machine automatically returns to point (A)
The display changes to:
1 BREAK 2 ARC 3 CURVE 4 LINE 5 ZIG
4 LINE Joins starting point A to end point B with ONE straight seam
Press 4 and ENTER
The display changes to:
BREAK LINE
STITCH LENGTH 3.0mm
Insert the required stitch length. E.g. 3.1mm insert 3 and 1
Press ENTER
The following appears on the display::
MAKE 1Y
LINE DATA 2N
Press 1 and ENTER
Press the JOG+ key and move near the left bar
Press the MODIFY key
The display changes to:
PRESS HOME KEY
Press HOME
To Next Page
Loading...