Vi.Be.Mac V3L - List of Errors and Messages Mitsubishi Type B; LIST of ERRORS (E - XX)

VI.BE.MAC.S.p.A.
pag.15
14. LIST OF ERRORS AND MESSAGES MITSUBISHI TYPE "B"
14.1. LIST OF ERRORS (E - xx)
If an error is reported, turn off the machine and check for the cause, before turning on again.
E - 01 Too much current to the Motor Check motor connection
Machine turns with difficulty Check whether the sewing machine is hard to turn or if the
machine is blocked
E - 02 Excess tension Check supply voltage
E - 03 Error on motor encoder Check that the motor encoder is connected properly.
Check that the motor encoder is connected properly.
Check the belt between the motor and the sewing machine
Check whether the sewing machine is hard to turn or if the
machine is blocked
Check whether the motor is blocked
E - 04 Error on Electric Motor Check that the motor connector is inserted properly
E - 08 Error on Synchroniser Check that the Synchroniser connector is inserted properly
Check in the TEST that the UP/DN signals are correct
E - 09 Error on solenoid valves Check that there are no solenoid valve coils or
SHORT CIRCUIT their connections in SHORT CIRCUIT
E - 20 Error in the SOFTWARE Reload the System Software from the special disk
(available, on request, from VI.BE.MAC.)
E - 25 Air Pressure too low Check for the cause and restore correct pressure
E - 26 Too much current to the panel Check the connections of the STEP-BY-STEP motors
STEP-BY-STEP MOTORS Check whether the motors are in short circuit
E - 28 The message appears for Check the electrical connection and try again
a few seconds when turning off
the machine (PROTECTION)