VI.BE.MAC.S.p.A.
pag.23
20. LIFTING THE SEWING HEAD
Before carrying out any operation, make sure that:
• the unit is off, by pressing the OFF key on the main switch.
• the unit is disconnected from the general compressed air system.
• the wheels at the base of the stand of the machine are blocked.
Loosen the pneumatic connector above the table
Loosen the clamping straps in the supply cable to the Step by Step motors under the table
Remove the belt covering safety guard fixed to the table with wood screws.
Remove the transmission belt from the pulley of the electric motor.
Remove the transparent LEXAN X-axis guide safety cover on the left, by unscrewing the clamping screws.
Move the loading carriage completely to the left.
Now with two people (one on each side) turn the sewing head so that it pivots on its hinges on the left side
of the sewing head base, until the sewing head rests on the wooden support.
ATTENTION: Do not put any pressure on the LOADER when lifting the head, so as not to lose the
alignment, but place both hands on the casing.
ATTENTION: DANGER OF CRUSHING HANDS
One person should now hold the machine in a vertical position while the other can carry out the
necessary controls.
To lower the machine, again with a minimum of two people, pay maximum attention to avoid the danger
of crushing hands.
Make sure that the pneumatic connector does not end up under the pressure feet of the sewing head or the
equipment.
ATTENTION
Danger of crushing hands.
Always check their position
according to the action to be carried out.
To Next Page
Loading...