VI.BE.MAC.S.p.A.
pag.58
24. INSTRUCTIONS FOR LOADING THE SYSTEM SOFTWARE AND THE OPERATION
TABLES INTO THE CONTROL UNIT
24.1. LOADING THE SYSTEM SOFTWARE
Turn off the machine
Insert the floppy disk SYSTEM SOFTWARE VER. 459 in the driver
Press button "F" on the console, under the driver and, while holding it down, TURN ON THE MACHINE
F + MACHINE START-UP
The following appears on the display:
00. x x x (Type of machine)
THE NUMBER 10 APPEARS _ _ _ FOR THE 1006 MACHINE
The number 25 appears _ _ _ for the 2516 machine
Press the down directional arrow and select the type of machine required
Press the "D" key on the console
The following appears on the display:
LA. E n g (Type of language: E n g)
Press the down directional arrow and select the required language from those present
Eng = English Fra = French Ita = Italian Spa = Spanish Jap = Japanese
Press the "D" key on the console
The machine starts to read the disk in the driver. It takes about 10 minutes for the computer to read the data
and load it into memory.
When on the console appears RESET/TEACHING, press ENTER.
Now proceed with loading the operational system.
24.2. LOADING THE OPERATIONAL SYSTEM "SYSTEM TABLE"
Turn off the machine
Insert the Floppy disk SET EMBROIDERY/LABEL or POCKET-SETTING or FLY/PAD in the driver.
Press button "B" on the console, under the driver and, while holding it down, TURN ON THE MACHINE
B + MACHINE START-UP
The following appears on the display:
T B L. r d (READ TABLES)
Press the "D" key on the console
The machine starts to read the disk in the driver.
It takes about 5 minutes for the computer to read the data and load it into memory.
The number of the programme reappears in the console, the machine is ready to operate.
Always check, referring to paragraph 6.OPERATING SYSTEM that the unit has called up into memory the
type of operation required.
To Next Page
Loading...