Vi.Be.Mac V3L - Page 60

To Previous Page

INDUSTRIAL SEWING MACHINES - AUTOMATIC UNITS - TECHNICAL DEVICES

S.p.A.

37057 S. GIOVANNI LUPATOTO (VR) ITALY - Via Monte Pastello, 7/I

Tel. (+39) 045 8778151 / 8778152 r.a. - Telefax (+39) 045 8779024

http://www.vibemac.com • E-mail: vibemac@vibemac.com

ineagrafica

Main Page

Table of Contents3
General Machine Specifications5
Supply Voltage5
Compressed Air Consumption and Pressure5
Dimensions and Weight5
Conditions of Use6
Form of Guarantee6
Work Station7
Machine Start-Up8
Stopping the Machine8
Calling up a Programme8
Writing a Programme9
Cancelling a Programme9
Copying Programmes10
Setting Bobbin and Production Counters11
Resetting Bobbin Counter11
RESETTING PRODUCTION COUNTER (Start of Production)11
Changing the Form on the Equipment between Two Different Sewings12
From One Design to Another of Different Shape12
From One Label to Another of Different Shape12
Changing the Equipment13
From the Design to the Label13
Operating System15
Operating System Selection15
List of Errors and Messages Mitsubishi Type "B16
LIST of ERRORS (E - XX)16
LIST of MESSAGES (M - XX)17
Electrical Connection19
Inputs19
Outputs20
Solenoid Valves21
Control Circuit22
ELECTRIC LIMIT STOPS for LOADER22
Flow Regulators22
Loading Cylinder Expansions22
Original Point Sensors23
Pneumatic System23
Lifting the Sewing Head24
Operating Software Parameters25
Varying Timer Settings with Automatic Cycle Prmb = 125
Varying Timer Settings with Automatic Cycle Prmb = 226
Inputs / Outputs Test27
Material Carriage Parameter Control - Tension Release Time During Cut Cycle30
CONTROL of SET SPEEDS (FEED and SEWING) and SLOW START FUNCTION31
Programming33
General Specifications33
Memory33
Stitch Length33
Sewing Speed33
Codes33
Method of Programming33
Programming an Embroidery34
Re-Programming the Second Seam in an Embroidery36
Programming a Label38
Modifications to the Programme40
General Specifications40
Memory41
Stitch Length41
Moving the Entire Programme42
Modifying an Angle Inserted in the Programme43
Modifying a Curve Inserted in the Programme45
MODIFYING the SEWING SPEED (N° of Stitches)47
Adding Codes49
Removing Codes50
Re-Programming the Seam of a Straight Side51
Modifying the Position of a Seam from a Specific Point to the End of the Programme, Moving the Stitches53
ENLARGING or REDUCING a PROGRAMME (Varying the X AXIS% and the y AXIS% Values)55
Rotation of a Programme57
Instructions for Loading the System Software and the Operation Tables into the Control Unit59
Loading the System Software59
Loading the Operational System "System Table59

Vi.Be.Mac V3L - Page 60

Table of Contents