VI.BE.MAC.S.p.A.
pag.5
2. CONDITIONS OF USE
“Normal” operation includes all those operations for the preparation and application of a pocket onto
trousers, respecting the following conditions:
• the operator must first have read and fully understood all parts of this manual.
• the operator must abide by all the instructions in this manual and "CE" regulations
• the maximum width of the pocket EMBROIDERY must be 220mm
• the maximum height of the pocket EMBROIDERY must be 90mm.
• the maximum width of the LABEL must be 110mm
• the maximum height of the LABEL must be 80mm.
• the material thickness of the trousers where the LABEL is to be applied must not be greater than 5 mm
• all safety regulations must be respected; safety covers installed by the manufacturer must not be
removed.
• the electrical supply must be constant.
• the machine must be earthed to prevent disturbances and electric shocks.
• the machine must not operate at high temperatures (above 40°c) or low temperatures (below 10°c).
• water or other liquids (with the exception of oil) must not get into the sewing machine.
• water or other liquids must not get into the control panel, solenoid valves and cylinders.
• the automatic unit must be installed on a flat surface checking that the feet rest all together on the
ground, and are blocked with the special nut.
• the automatic unit must not be used in areas where there is explosive gas, powder or oil vapours.
• the machine must not be connected to a compressed air circuit containing water or other liquids in the
pressure circuit.
• the machine must be connected to a compressed air circuit with a constant minimum internal pressure
of 5.5 bar.
• the operator must use soundproof earplugs to prevent damage to the ear.
• installation of the machine and extraordinary maintenance must be performed by qualified personnel.
The manufacturer declines any responsibility for damage to persons or things caused by the
machine in cases where:
• the unit is not properly installed on an even surface.
• installation of the machine is not performed by qualified personnel.
• ordinary and extraordinary maintenance of the machine have not been performed by qualified
personnel.
• the electrical supply is not constant.
• the air pressure in the pneumatic circuit does not satisfy the requirements.
• routine maintenance of the unit is not performed as required.
• non-original spare parts or parts which are not specified for the model are used.
• there is a partial or total lack of observance of the instructions on the part of the user.
• the maximum thickness of the trousers, at the point where the pocket is to be applied, is not
respected.
• the operator has been working with broken or unsuitable needles, thereby ruining the trousers.
Under no circumstances:
• deactivate the safety devices provided by the manufacturer, thereby making the machine dangerous
for the operator.
• remove the safety covers and devices from their position, thereby making the machine dangerous for
the operator.
• remove the eye protection shield without supplying the operator with special eye protection glasses in
compliance with current regulations.
• modify the machine, without authorisation from the manufacturer, thereby making the machine
dangerous for the operator.
2.1. FORM OF GUARANTEE
A guarantee of 1 (one) year applies to all parts that make up the unit, when delivered to the manufacturer
and found to be defective.
All parts damaged through improper use by the operator, and/or improper adjustment of the unit by
technical personnel not authorised by VI.BE.MAC. S.p.A., will NOT be considered as defective by the
manufacturer. In this case these will be charged for, including all transport costs and/or subsequent
installation costs.
To Next Page
Loading...