VI.BE.MAC.S.p.A.
pag.30
21.5.CONTROL OF SET SPEEDS (FEED and SEWING) AND SLOW START FUNCTION
On the command console fixed to the card cabinet under the Loader:
Press the F key
The following appears on the display:
F U N C
Press the down arrow and the B key together
The following appears on the display:
P - b (B mode)
Hold the two keys down until the display changes to:
W b t. o f
Press the down arrow key until the following appears on the display:
F e s. x (MOVING speed x = Adjusted speed value)
The parameter F e s. can be adjusted to between 0 (minimum speed) and 9 (MAXIMUM speed).
Standard value = 5
Press the down arrow until the following appears on the display:
H = XXXX (MAXIMUM speed XXXX = Adjusted speed value)
Use the D key to change the units
Use the C key to change the tens
Use the B key to change the hundreds
Use the A key to change the thousands
Adjust to a value of 2300 revolutions (2100 while running in)
Press the down arrow key until the following appears on the display:
L = XXXX (MINIMUM speed XXXX = Adjusted speed value)
Use the D key to change the units
Use the C key to change the tens
Use the B key to change the hundreds
Use the A key to change the thousands
Adjust to a value of 200
Press the down arrow key until the following appears on the display:
M = XXXX (MEDIUM-HIGH speed XXXX = Adjusted speed value)
Use the D key to change the units
Use the C key to change the tens
Use the B key to change the hundreds
Use the A key to change the thousands
Adjust to a value of 1000
Press the down arrow key until the following appears on the display:
n = XXXX (MEDIUM-LOW speed XXXX = Adjusted speed value)
Use the D key to change the units
Use the C key to change the tens
Use the B key to change the hundreds
Use the A key to change the thousands
Adjust to a value of 700
Press the down arrow key until the following appears on the display:
t = XXXX (TRIM speed XXXX = Adjusted speed value)
To Next Page
Loading...