VI.BE.MAC.S.p.A.
pag.17
M - 27 The reduction value requested The value inserted is below 10%
is too low Insert the correct value
M - 28 The increase value requested The value inserted is above 200%
is too high Insert the correct value
M - 29 The stitch length value The value inserted is over 12.7 mm
requested is too high Insert the correct value
M - 30 The number of stitches in Press the ENTER key and check the set value of the
the programme is too high FLB function
M - 33 Data elaboration in progress The machines elaborates the data of the program
M - 37 The value inserted is too high Insert the correct value
M - 38 The number or data inserted Reinsert the number or data
is wrong Insert the correct value
M - 41 The stitch length value The value inserted is 0.0 mm
requested is too low Insert the correct value
M - 42 The number or data inserted Reinsert the number or data
is wrong Insert the correct value
M - 43 The value inserted is too low Insert the correct value
M - 44 The machine is going to Wait until it reaches the modification starting point
the 1st modification point (modification, BLOCK option)
M - 45 The machine is going to Wait until it reaches the sewing starting point
the 1st sewing point (modification, FEED option)
M - 53 The STOP button is pressed Unblock the STOP button
M - 54 Bobbin Counter The machine has reached the programmed number
DOWN COUNTER Press ENTER to reset the counter
M - 55 Danger stop Turn off the machine immediately at the main switch
M - 57 Operation impossible Press ENTER and then the HOME key
Not at Departure Point
To Next Page
Loading...