Vi.Be.Mac V3L - Page 4

VI.BE.MAC.S.p.A.
pag.3
22.8.RE-PROGRAMMING THE SEAM OF A STRAIGHT SIDE...............................................................................50
22.9.MODIFYING THE POSITION OF A SEAM FROM A SPECIFIC POINT TO THE END OF THE
PROGRAMME, MOVING THE STITCHES .................................................................................................................52
22.10.ENLARGING OR REDUCING A PROGRAMME (varying the X AXIS% and the Y AXIS% values) ..........54
22.11.ROTATION OF A PROGRAMME.......................................................................................................................56
23. INSTRUCTIONS FOR LOADING THE SYSTEM SOFTWARE AND THE OPERATION TABLES INTO
THE CONTROL UNIT.........................................................................................................................................................58
23.1.LOADING THE SYSTEM SOFTWARE................................................................................................................58
23.2.LOADING THE OPERATIONAL SYSTEM "SYSTEM TABLE" ......................................................................58