Victor CUTMASTER User Manual (English)

Other manuals for Victor CUTMASTER

Questions and Answers:

C
Christine HarveyJul 26, 2025
What to do if the GAS LED is OFF, and FAULT and MIN pressure indicators are flashing on my Victor CUTMASTER?
- J
  Julia MoralesJul 26, 2025
  If the GAS LED is OFF and both FAULT and MIN pressure indicators are flashing on your Victor Welding System, it could be due to several reasons: * The gas supply might not be connected. Ensure the gas supply is properly connected to the unit. * The gas supply might not be turned on. Make sure to turn the gas supply ON. * The gas supply pressure might be too low. In this case, set the air supply inlet pressure to 120 psi. * The AIR PRESSURE CONTROL regulator might be set too low. Adjust the regulator to set the air pressure.
N
Nathan EricksonJul 30, 2025
What does it mean when the FAULT and 70 PSI indicators are flashing on my Victor CUTMASTER?
- A
  alexanderamberJul 30, 2025
  If the FAULT and 70 PSI indicators are flashing on your Victor Welding System, it could be due to: * A loose shield cup. Hand-tighten the shield cup until it is snug. * The torch not being properly connected to the power supply. Ensure the torch ATC is securely fastened to the unit. * A problem in the torch and leads PIP circuit. Consider replacing the torch and leads.
R
Rhonda WoodwardAug 4, 2025
Why is the A/C Indicator not lighting when the ON/OFF switch is ON in my Victor CUTMASTER?
- T
  Taylor HernandezAug 5, 2025
  If the ON/OFF switch is in the ON position but the A/C indicator light is not illuminating on your Victor Welding System, consider the following possibilities: * The primary power disconnect may be in the OFF position. If so, turn the primary power disconnect switch to the ON position. * The primary fuses or breakers may be blown or tripped. Have a qualified person check the primary fuses or breakers and connect the unit to a known good primary power receptacle. * The unit's internal fuse may be blown. Try replacing the fuse. If it blows again, the unit should be inspected by a qualified technician.
M
Matthew DanielsAug 10, 2025
What should I do if the FAULT and 75 PSI indicators are flashing on my Victor CUTMASTER Welding System?
- J
  Jack CollinsAug 10, 2025
  If the FAULT and 75 PSI indicators are flashing on your Victor Welding System, it could indicate that the start signal is active when the ON/OFF switch is turned to the ON position. This can occur if the hand torch switch or hand pendant switch is held closed, or if the CNC START signal is active low. Try releasing the START signal source. Alternatively, there may be a problem in the torch and leads switch circuit, requiring replacement of the torch and leads.
T
tiffanyyoungAug 15, 2025
Why is the TEMPERATURE indicator ON and the FAULT indicator flashing on my Victor Welding System?
- N
  Nicholas WilsonAug 15, 2025
  If the TEMPERATURE indicator is ON and the FAULT indicator is flashing on your Victor Welding System, it could be due to: * Obstructed airflow through or around the unit. * Exceeding the unit's duty cycle. Allow the unit to cool down.
J
Jerry MooreAug 19, 2025
What to do if Fault indicator and 65 PSI indicator are flashing on Victor CUTMASTER?
- J
  Jesse GonzalezAug 19, 2025
  If the Fault indicator and the 65 PSI indicator are flashing on your Victor Welding System, it could be due to: * Improper input voltage. Check for proper primary input voltage. * A primary input voltage problem. Have a qualified person check the primary voltage to ensure it meets the unit requirements.