INTRODUCTION
CUTMASTER 10MM, 12MM
Manual 0-5230 2-1 Introduction
SECTION 2 SYSTEM:
INTRODUCTION
2.01 How to Use This Manual
To ensure safe operation, read the entire manual, including the chap-
ter on safety instructions and warnings. Throughout this manual,
the word WARNING, CAUTION and NOTE may appear. Pay particular
attention to the information provided under these headings. These
special annotations are easily recognized as follows:
NOTE
Offers helpful information concerning certain operat-
ing procedures. Notes will be shown in italics
CAUTION
Refers to possible equipment damage. Cautions will
be shown in bold type.
WARNING
Gives information regarding possible personal injury.
Warnings will be enclosed in a box such as this.
You will also notice icons from the safety section appearing
throughout the manual. These are to advise you of specific types
of hazards or cautions related to the portion of information that fol-
lows. Some may have multiple hazards that apply and would look
something like this:
2.02 Equipment Identification
The unit’s identification number (specification or part number),
model, and serial number usually appear on a nameplate attached
to the machine. Equipment which does not have a nameplate at-
tached to the machine is identified only by the specification or part
number printed on the shipping container. Record these numbers
for future reference.
2.03 Receipt of Equipment
When you receive the equipment, check it against the invoice to
make sure it is complete and inspect the equipment for possible
damage due to shipping. If there is any damage, notify the carrier
immediately to file a claim. Furnish complete information concern-
ing damage claims or shipping errors to the location in your area
listed in the inside back cover of this manual. Include all equipment
identification numbers as described above along with a full descrip-
tion of the parts in error.
2.04 Transportation Methods
Disconnect input power conduc-
tors from de-energized supply line before moving the cutting power
source.
Lift unit with handle on top of case. Use handcart or similar device
of adequate capacity. If using a fork lift vehicle, secure the unit on
a proper skid before transporting.
To Next Page
Loading...
