Victor CUTMASTER Service Manual

GENERAL INFORMATION CUTMASTER 10MM, 12MM
Manual 0-5230 1-5 General Informatio
n
WARNING
FLYING METAL or DIRT can injure eyes.
• Wearsafetyglasseswithsideshieldsorfaceshieldduring
servicing.
• Becarefulnottoshortmetaltools,parts,orwirestogether
during testing and servicing.
WARNING
HOT PARTS can cause sever burns.
• Donottouchhotpartsbarehanded.
• Allowcoolingperiodbeforeworkingonequipment.
• To handle not parts,useproper tools and/or wearheavy,
insulated welding gloves and clothing to prevent burns.
WARNING
EXPLODING PARTS can cause injury.
• Failedpartscanexplodeorcauseotherpartstoexplodewhen
power is applied to inverters.
• Alwayswearafaceshieldandlongsleeveswhenservicing
inverters.
WARNING
SHOCK HAZARD from testing.
• TurnOffcuttingpowersourceorstopenginebeforemaking
or changing meter lead connections.
• Useatleastonemeterleadthathasaself-retainingspring
clip such as an alligator clip.
• Readinstructionsfortestequipment.
WARNING
FALLING UNIT can cause injury.
• Useliftingeyetoliftunitonly,NOTrunninggear,gascylin-
ders, or any other accessories.
• Useequipmentofadequatecapacitytoliftandsupportunit.
• Ifusingliftforkstomoveunit,besureforksarelongenough
to extend beyond opposite side of unit.
WARNING
MOVING PARTS can cause injury,
• Keepawayfrommovingpartssuchasfans.
• Keepawayfrompinchpointssuchasdriverolls.
• Haveonlyqualiedpersonsremovepanels,covers,orguards
for maintenance as necessary.
• Keephands,hair,looseclothing,andtoolsawayfrommoving
parts.
• Reinstallpanels, covers, orguards when maintenanceis
finished and before reconnecting input power.
WARNING
OVERUSE can cause OVERHEATING.
• Allowcoolingperiod;followrateddutycycle.
• Reducecurrentorreducedutycyclebeforestartingtocut
again.
• Donotblockorlterairowtounit.
!
WARNING
READ INSTRUCTIONS.
• UseTestingBooklet(PartNo.150853)whenservicingthis
unit.
• ConsulttheOwner’sManualforcuttingsafetyprecautions.
• Useonlygenuinereplacementpartsfromthemanufacturer

Victor CUTMASTER Specifications

General

Brand	Victor
Model	CUTMASTER
Category	Welding System
Language	English