!
WARNINGS
Read and understand this entire Manual and your employer’s safety practices before installing,
operating, or servicing the equipment.
While the information contained in this Manual represents the Manufacturer's best judgement,
the Manufacturer assumes no liability for its use.
Plasma Cutting Power Source
CutMaster™ 10mm Plant - Part Number 1-4730-6
Cutmaster™ 12mm Plant - Part Number 1-4200-6
SL60 Torch™
Service Manual Number 0-5230
Published by:
Thermal Dynamics Corporation
82 Benning Street
West Lebanon, New Hampshire, USA 03784
(603) 298-5711
www.victortechnologies.com
Copyright 2012, 2013 by
Victor Technologies International, Inc.
All rights reserved.
Reproduction of this work, in whole or in part, without written permission of the pub-
lisher is prohibited.
The publisher does not assume and hereby disclaims any liability to any party for any
loss or damage caused by any error or omission in this Manual, whether such error
results from negligence, accident, or any other cause.
Publication Date: December 5, 2012
Revision AB Date: May 27, 2013
Record the following information for Warranty purposes:
Where Purchased:_______________________________ ____________
Purchase Date:__________________________________ ____________
Power Supply Serial #:___________________________ _____________
Torch Serial #:___________________________________ ___________
i
To Next Page
Loading...
Need help?
General
