Videonics TM-3000 - Moving the Cursor; Project; Moving in the Color Menu

VIDEONICS TITLEMAKER 3000 PAGE 83
• To completely reset the unit, erasing everything and returning the unit to
factory condition, turn the POWER SWITCH on the back panel OFF; then
back on. While holding CMD + SHIFT + ACCENT, press and hold the
POWER key until the Edit Screen is displayed. (Note: If you hold the
POWER keys too long, alocked demo will beginplaying. To stop thedemo,
press ACCENT + SHIFT + DEMO.)
Warning:This will erase allprojects, all colors,etc. You cannot undo this
operation.
MovingtheCursor
• In the Editing Screen, the CMD and SHIFT keys modify the arrow keys:
Modifier key LEFT or RIGHT arrow UP or DOWN arrow
SHIFT Next start or end of line Start or end of next page
CMD (Command) Next start or end of line Start or end of current project
CMD (Command) + SHIFT Next start or end of line Start of next project
• Inthe Page Indexscreen, SHIFT causesthearrow keystomove afullscreen
at a time. CMD causes the arrow keys to move a project at a time. CMD +
SHIFT also moves a project at a time.
• SHIFT and CMD also modify the meanings of the MARK START and
MARK END keys, in both the Editing Screen and the Page Index screens:
• SHIFT + MARK START places a mark at the start of the current page
and SHIFT + MARK END places a mark at the end of the page.
• CMD + MARK START places a mark at the start of the current project
and CMD + MARK END places a mark at the end of the project.
Projects
• Use CMD + SHIFT + UP/DOWN to move to the next or previous project.
• CMD + NEW PAGE, while the Page Index is on the screen, creates a new
project.
• CMD + SHIFT +DELETE while in the Editing Screen erasesthe contents of
a project.
Moving In the Color Menu
• In the bottom sub-menu (with the color palette), use SHIFT with the arrow
keys to move the highlight a full screen of bars at a time.
• In the bottom sub-menu, use CMD + UP to move to the first pre-defined
color. Use CMD + DOWN to move to the first user-defined color.