Vigilant MX1 - Page 134

Vigilant MX1 Operator Manual Document: LT0344
Page 11-14 8 August 2017 Issue 2.4
Point
Point Description
Description
246.37.1
Smoke Control
Active
When this point is placed into the Operate state by a logic
equation the corresponding indicator on the Remote FBP turns
ON.
246.37.2
Spare Indicator
When this point is placed into the Operate state by a logic
equation the corresponding indicator on the Remote FBP turns
ON.
246.37.3
Spare Indicator A
NOT SUPPORTED
246.37.4
Spare Indicator B
NOT SUPPORTED
Point
Point
Description
Description
247.x.0
SID Comms Status
Provides the communication status of the remote SID.
247.x.1
SID MAF Status
Displays the MAF status of the remote SID. Refer to page 9-9
for the MAF Status conditions displayed.
247.x.2
NIC Fault Status
For SIDs that support this, displays the fault status of the remote
network interface (an I-HUB). Refer to the descriptions for the
points 241.32.1 through 241.32.13 (earlier in this section) for an
explanation of the faults that can appear.
247.x.3
NIC Warning Status
For SIDs that support this, displays the warning status of the
remote network interface (an I-HUB). Refer to the descriptions
for the points 241.32.1 through 241.32.13 (earlier in this section)
for an explanation of the warnings that can appear.
Value x is the SID number.
Equipment
247
– SID Points