Vigilant MX1 - Page 57

Document: LT0344 Vigilant MX1 Operator Manual
Issue 2.4 8 August 2017 Page 5-7
Fig 5-11 – Point Recall Display
Point numbering and usage is described in detail in Chapter 1, Point
Numbers (page 1-13).
The ALL ZNSF4 option in the Recall menu (see Figure 5-2) allows all
configured zones to be recalled.
If your panel is connected to a network you will see the following menu:
Fig 5-12 – Recall Zones Network Menu
Press:
 LOCALF1 to show the selected zones on the local MX1
 ALL SIDSF2 to show the selected zones on the network
 ENTR SIDF3 to show the selected zones on a particular MX1
panel. This will prompt you to enter the SID of the panel to search.
All configured zones will be displayed starting at the lowest numbered
zone, irrespective of the zone condition. An example is shown in Figure
5-13.
Zone 002 Std Detection G1 | ENTER
Factory | PREV
Normal | NEXT
| MENU
Fig 5-13 – Recall Zone Status Display
A
l
l
Z
o
n
e
s
Recall zones : ALL
|
LOCAL
|
ALL SIDS
|
ENTR SID
Select SIDs to search |
P
1
.
1
.
0
MIM
800
MX Device
|
ENTER
Office
|
PREV
Normal
|
NEXT
|
MENU
All Zones