D-302756 11
4. PROGRAMMING
4.1 General Guidance
We recommend programming the PowerMaster-10 on the work bench before actual installation. Operating
power may be obtained from the backup battery or from the AC power supply.
4.2 Entering the Installer Menu
The following procedure describes how to enter the Installer Menu.
To Enter the Installer Menu
1.
Make sure the system is disarmed and then press the button
repeatedly until the PowerMaster-10 display reads "INSTALLER MODE".
2.
3.
CODE Enter your Installer Code.
4.
or Press the or button repeatedly until the display reads the
desired setting option, for example, "ZONES/DEVICES".
You can program any other menu or press the or buttons to
take you to "
<OK> TO EXIT
".
4.2.1 Programming User Settings
This mode provides you with a gateway to the user functions through the regular user programming menu.
To Enter the User Settings Menu
1.
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
2.
Refer to the PowerMaster-10 User Guide for detailed procedures
Clicking the or buttons at any stage in the procedure will
take you to “
<OK> TO EXIT
”.
Caution! If after having programmed the user codes the system does not recognize your installer code,
this indicates you must have programmed a user code that is identical with your installer code. If so,
access the user menu and change the code that is identical with your installer code. This will re-validate
your installer code.
To Next Page
Loading...
Need help?
General
