48 D-302756
To Configure whether a missing device causes the system to become "NOT READY"
1.
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
2.
3.
or
4.
5.
or
Select between "normal", and "in supervision".
6.
You can now press the or button to program any other
menu in "
DEFINE PANEL
" or press the button to take you to "
<OK>
TO EXIT
".
4.8.11 Configuring the Time Period by which a Device is considered Missing
Here you determine the time limit for reception of supervision reports from various supervised wireless devices.
If any device does not report at least once within the selected time limit, an “INACTIVITY” alert is initiated.
The options are: 1, 2, 4, 8, 12 hours (default) and disable.
Note: To comply with EN requirements, 1 or 2 hours must be selected.
To Configure the Time Period by which a Device is Considered Missing
1.
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
2.
3.
or
4.
5.
or
Select between "superv time 1h", "superv time 2h", "superv time
4h", "superv time 8h", "superv time 12h" and "disable".
6.
You can now press the or button to program any other
menu in "
DEFINE PANEL
" or press the button to take you to "
<OK>
TO EXIT
".
15:SUPERVISION
superv time 12h
15:SUPERVISION
01:ENTRY DELAY 1
DEFINE PANEL
16:NOT READY
normal
16:NOT READY
01:ENTRY DELAY 1
DEFINE PANEL