12 D-302756
4.3 Navigation
This mode allows you to customize the control panel and adapt its characteristics and behavior to the requirements
of the particular user. To review the options within the control panel menus, repeatedly press the
or
button, until the desired option is displayed, then press the button.
You will mainly use 5 control pushbuttons during the entire programming process:
- to move one step forward in a menu.
- to move one step backward in a menu.
-
to enter the relevant menu or confirm data.
- to move one level up in a menu.
- to return to the "OK TO EXIT" state.
The sounds you will hear while programming are:
- Single beep, heard whenever a key is pressed.
- Double beep, indicates automatic return to the normal operating mode (by timeout).
☺
- Happy Melody (- - - –––), indicates successful completion of an operation.
- Sad Melody (–––––), indicates a wrong move or rejection.
If you enter an invalid installer code 5 times, the keypad will be automatically disabled for 90 seconds and the
message WRONG PASSWORD will be displayed.
4.4 Permissions and User Codes
The PowerMaster-10 system includes four code levels, as follows:
• Installer Code: By using the installer code, the menu enables changing the installer code.
• Master Installer Code: By using the master installer code, the menu enables changing both master installer
code and installer code.
• User Code: See PowerMaster-10 User Guide
• Master User Code: See PowerMaster-10 User Guide
Not every system includes a MASTER INSTALLER code. In a system with an INSTALLER code only, the installer
can use all the functions in the system.
The following actions can be done only by using the master installer code:
• Changing master installer code.
• Resetting the PowerMaster-10 parameters to the default parameters,
• Defining specific communication parameters.
You are expected to use this code only once for gaining initial access, and replace it with a secret code known
only to yourself.
4.4.1 Setting a New Installer Code
To set an installer code, perform the actions that are presented below. When you are instructed to enter code,
enter a 4-digit code.
A. To Set a New Installer Code
1.
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
2.
Note: The menu displayed within the dashed box appears only if the control panel
includes the Master Installer Code.
3.
4.
NEW INST. CODE
NEW MASTER CODE
NEW INSTL CODE
To Next Page
Loading...
Need help?
General
