Visonic POWERMASTER-10 - INSTALLER GUIDE User Manual

D-302756 15
To Configure Permissions for System Reset after an Alarm Event
1.
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
2.
3.
4.
or
5.
Select between "user reset" (default), "engineer reset" and "anti
code reset".
You can now press the or button to program any other menu
in " DEFINE PANEL " or press the button to take you to " <OK> TO EXIT ".
4.4.6 Configuring a Duress Code
A duress alarm (ambush) message can be sent to the Monitoring Station if the user is forced to disarm the system
under violence or menace. To initiate a duress message, the user must disarm the system with the duress code
(2580 by default). Here you can change the code digits or enter "0000" to disable the duress feature. The system
does not allow the user to program the duress code saved in this memory location as an existing user
code.
Note: Duress Code is not applicable in the UK.
To Configure a Duress Code
1.
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
2.
3.
4.
or
5.
Change the code or enter 0000 to disable the duress function.
You can now press the or button to program any other menu in
" DEFINE PANEL " or press the button to take you to " <OK> TO EXIT ".
0
1:ENTRY DELAY 1
2
5:RESET OPTION
2
3:DURESS
D
URESS CODE 2580
2
3:DURESS
0
1:ENTRY DELAY 1
DEFINE PANEL
2
5:RESET OPTION
u
ser reset
DEFINE PANEL

Visonic POWERMASTER-10 - INSTALLER GUIDE Specifications

General

Category	Security System
Model	POWERMASTER-10
Wireless Protocol	PowerG
Backup Battery	Yes
User Codes	Up to 48 user codes
Type	Wireless Alarm System
Partitions	3
Communication	GSM
Wireless Frequency	868 MHz
Keypads	Up to 8 keypads
Event Log	1000 events
Power Supply	External power supply
Backup Battery Voltage	7.2V
Operating Temperature	-10°C to +50°C
Humidity	85% non-condensing
Zones	Up to 30 wireless zones