EasyManuals Logo

Visonic POWERMASTER-10 - INSTALLER GUIDE User Manual

Visonic POWERMASTER-10 - INSTALLER GUIDE
86 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #43 background imageLoading...
Page #43 background image
42 D-302756
42.
43.
44.
3rd SMS TEL. NO.
Enter the third SMS phone number (including area code, 16 digits max.)
to which pre-selected event types will be reported.
45.
46.
47.
48.
4th SMS TEL. NO.
Enter the fourht SMS phone number (including area code, 16 digits max.)
to which pre-selected event types will be reported.
49.
You can now press the button to take you to the "
1st private
tel#
" menu (see step C. To Configure Event Types to be Reported to
User), or press the button to take you to "
<OK> TO EXIT
".
4.8 Security System Configuration
4.8.1 Enable Cross Zoning
Here you determine whether cross zoning will be active or inactive. Cross zoning is a method used to counteract
false alarms - an alarm will not be initiated unless two adjacent zones are violated within a 30-second time limit.
This feature is active only when arming AWAY and only with zone couples from zone No. 18 to 27
(18 and 19,
20 and 21, etc.). You may use any one of these zone couples to create a “cross-zoned” area.
Note: If one of two crossed zones is bypassed (see Para. 4.3.5), the remaining zone will function independently.
Note: Every 2 crossed zones must be of the allowed zone type (Interior, Perimeter, Perimeter follower).
The options are: cross zone ON and cross zone OFF (default).
Cross zoning is not applicable in Entry/ Exit zones and 24h zones (Fire, Emergency, 24h audible, 24h silent).
To Enable Cross Zoning
1.
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
2.
3.
or
4.
5.
or
Select between "cross zone OFF" and "cross zone ON".
6.
cross zone OFF
14:CROSS ZONING
01:ENTRY DELAY 1
DEFINE PANEL
4th SMS tel#
4th SMS tel#
3rd SMS tel#
3rd SMS tel#
2nd SMS tel#

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Visonic POWERMASTER-10 - INSTALLER GUIDE and is the answer not in the manual?

Visonic POWERMASTER-10 - INSTALLER GUIDE Specifications

General IconGeneral
CategorySecurity System
ModelPOWERMASTER-10
Wireless ProtocolPowerG
Backup BatteryYes
User CodesUp to 48 user codes
TypeWireless Alarm System
Partitions3
CommunicationGSM
Wireless Frequency868 MHz
KeypadsUp to 8 keypads
Event Log1000 events
Power SupplyExternal power supply
Backup Battery Voltage7.2V
Operating Temperature-10°C to +50°C
Humidity85% non-condensing
ZonesUp to 30 wireless zones

Related product manuals