30 D-302756
32.
Here you determine whether the alarm system will report events to the
Monitoring Station via the GSM Voice channel.
33.
34.
or
Select between "disable" and "enable".
35.
36.
Here you determine whether the control panel will stay continuously
connected via GPRS communication, or, temporarily connected to receive
event reports only.
37.
38.
or
Select between "off on timeout" and "always ON".
39.
You can now press the button to take you to the "
GPRS REPORT
"
menu, or press the button to take you to "
<OK> TO EXIT
".
Key Functionality
Moves the cursor from left to right.
Long press for speed.
Moves the cursor from right to left.
Long press for speed.
Scrolls upward the sequence of inserted digits.
Long press for speed.
Scrolls downward the sequence of inserted digits.
Long press for speed.
Places cursor to extreme right position of edit string and shows the last 16 digits of edit string.
Reverts to previous or top menu without saving the edit string.
Reverts to "<OK> TO EXIT" without saving the edit string.
Saves and reverts to previous menu.
Clears all digits to the right of cursor.
Clears one digit by cursor.
Selects between uppercase or lowercase digits.
4.7.3 Configuring Event Reporting to Monitoring Station.
Here you determine which types of event will be reported to Monitoring Stations. Due to lack of space in the
display, abbreviations are used: alarm is “alrm”, alert is “alrt” and open/close is “o/c”. The asterisk (J) is a
separator between events reported to Monitoring Station 1 and events reported to Monitoring Station 2.
Messages are divided by type into the following groups:
SESSION TIMEOUT
FORCE HOME NTWK.
To Next Page
Loading...
Need help?
General
