Visonic POWERMASTER-10 - INSTALLER GUIDE User Manual

D-302756 29
12.
Here you determine whether the alarm system will report events to the
Monitoring Station via the SMS Channel.
13.
14.
or
Select between "disable" and "enable".
15.
16.
17.
18.
APN NAME
Enter the name of the APN Access Point used for the internet settings for
the GPRS (up to 40 digits).
Note: The table at the end of this section provides a list of the keys used
by the PowerMaster-10 editor.
19.
20.
21.
22.
APN USERNAME
Enter the username of the APN used for GPRS communications (up to
30 digits).
Note: The table at the end of this section provides a list of the keys used
by the PowerMaster-10 editor.
23.
24.
25.
26.
APN PASSWORD
Enter the password of the APN used for GPRS communications (up to 16
digits).
Note: The table at the end of this section provides a list of the keys used
by the PowerMaster-10 editor.
27.
28.
29.
30.
PIN CODE
Enter the PIN code of the SIM card installed in the PowerMaster-10 unit
(up to 16 digits).
31.
PIN CODE
GPRS PASSWORD
GPRS USERNAME
GPRS USERNAME
GPRS APN
GPRS PASSWORD
PIN CODE
GPRS APN
SMS REPORT
disable

SMS REPORT

Visonic POWERMASTER-10 - INSTALLER GUIDE Specifications

General

Category	Security System
Model	POWERMASTER-10
Wireless Protocol	PowerG
Backup Battery	Yes
User Codes	Up to 48 user codes
Type	Wireless Alarm System
Partitions	3
Communication	GSM
Wireless Frequency	868 MHz
Keypads	Up to 8 keypads
Event Log	1000 events
Power Supply	External power supply
Backup Battery Voltage	7.2V
Operating Temperature	-10°C to +50°C
Humidity	85% non-condensing
Zones	Up to 30 wireless zones