Visonic POWERMASTER-10 - INSTALLER GUIDE User Manual

26 D-302756
4.
5.
or
Select between "piezo siren ON" and "piezo siren OFF".
6.
You can now press the or button to program any other
menu in " DEFINE PANEL " or press the button to take you to " <OK>
TO EXIT ".
4.6.3 Configuring the Period of Strobe Light Activation
Here you can define the period of strobe light activation when the siren is in alarm state.
Options: 5 minutes, 10 minutes, 20 minutes (default), 40 minutes and 60 minutes.
To Configure the Period of Strobe Light Activation
1.
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
2.
3.
or
4.
5.
or
Select between "5 minutes", "10 minutes", "20 minutes", "40
minutes" and "60 minutes".
6.
You can now press the or button to program any other
menu in " DEFINE PANEL " or press the button to take you to " <OK>
TO EXIT ".
4.6.4 Enabling Siren Activation upon Telephone Line Failure
Here you determine whether the siren will be activated or not when the telephone line fails during system armed
state. Available options are: enable on fail, disable on fail (default).
To Enable Siren Activation upon Telephone Line Failure
1.
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
2.
3.
or
27:SIREN ON LINE
01:ENTRY DELAY 1
DEFINE PANEL
40:STROBE TIME
20 minutes

40:STROBE TIME
01:ENTRY DELAY 1
DEFINE PANEL
24:PIEZO SIREN
piezo siren ON


Visonic POWERMASTER-10 - INSTALLER GUIDE Specifications

General

Category	Security System
Model	POWERMASTER-10
Wireless Protocol	PowerG
Backup Battery	Yes
User Codes	Up to 48 user codes
Type	Wireless Alarm System
Partitions	3
Communication	GSM
Wireless Frequency	868 MHz
Keypads	Up to 8 keypads
Event Log	1000 events
Power Supply	External power supply
Backup Battery Voltage	7.2V
Operating Temperature	-10°C to +50°C
Humidity	85% non-condensing
Zones	Up to 30 wireless zones