D-302756 41
27.
or
Select between "1 attempt", "2 attempts", "3 attempts" and "4
attempts".
Attention! A maximum of 2 dialing attempts is permitted by the
Australian Telecommunication Authority.
28.
29.
Here you determine whether the system will use the single acknowledge
or the all acknowledge
mode when reporting to private telephones.
Note: In the single acknowledge
mode, receiving an acknowledge signal
from a single telephone is sufficient to consider the current event closed
and call off the communication session. The remaining telephones serve
for backup purposes only. In the all acknowledge
mode, an acknowledge
signal must be received from each telephone before the current event is
considered reported.
30.
31.
or
Select between "single ack" and "all ack".
32.
33.
You can now press the button to take you to the "
SMS REPORT
TEL#
" menu (see the next section), or press the button to take
you to "
<OK> TO EXIT
".
D. To Configure Reports to User by SMS
34.
35.
36.
37.
1st SMS TEL. NO.
Enter the first SMS phone number (including area code, 16 digits max.)
to which pre-selected event types will be reported.
38.
39.
40.
41.
2nd SMS TEL. NO.
Enter the second SMS phone number (including area code, 16 digits
max.) to which pre-selected event types will be reported.
2nd SMS tel#
1st SMS tel#
VOICE REPORT
1st SMS tel#
SMS REPORT TEL#
VOICE REPORT
Tel. acknowledge
Redial attempts
single ack
Tel. acknowledge
3 attempts
To Next Page
Loading...
Need help?
General
