Wacker Neuson G 240

Table of Contents
G 230 / G 240
wc_bo5000186930_09_FM10TOC.fm
8
7 Operation (Basler Controller) 54
7.1 Main Circuit Breaker ........................................................................... 54
7.2 Engine Start Switch ............................................................................55
7.3 Genset Pre-Alarms and Alarms (Shut-Down Conditions) ................... 56
7.4 Overcurrent Condition .........................................................................57
7.5 Idle Switch .......................................................................................... 57
7.6 Diesel Particulate Filter (DPF) ............................................................ 58
7.7 Using the Lugs and the Convenience Receptacles ............................59
7.8 Selecting the Voltage .......................................................................... 60
7.9 Before Starting the Machine ...............................................................63
7.10 Starting and Running the Generator ...................................................64
7.11 Stopping the Machine .........................................................................66
7.12 Emergency Stop Switch ......................................................................66
7.13 LCD Panel: Monitoring Machine Operation ........................................67
8 Working with Basler Controller 69
8.1 How to Use the Genset Controller LCD and Keypad ..........................69
8.2 Menu Diagram of the Genset Controller .............................................70
8.3 Menu Diagram Components ............................................................... 71
8.4 Using the Metering and Settings Menus .............................................72
8.5 Logging in to the Genset Controller by Entering the Password .......... 73
8.6 Adjusting the LCD Screen Contrast ....................................................76
8.7 Changing the Time/Date Settings .......................................................77
8.8 Changing the Sender Fail Time Delays ..............................................78
8.9 Changing the Units of Measure ..........................................................80
8.10 Changing the Low Fuel Pre-Alarm Setting ......................................... 82
8.11 Changing or Disabling the Low Fuel Alarm Setting ............................84
8.12 Changing the Cooldown Time Setting ................................................ 86
8.13 Changing the Pre-Crank Time Delay (Glow Plug Timer) ....................88
8.14 Changing the Maintenance Interval ....................................................90
8.15 Resetting the Maintenance Interval Pre-Alarm ................................... 92
8.16 Resetting a Loss of Voltage Pre-Alarm ............................................... 94
8.17 Accessing and Using the Event Log ................................................... 95
9 Operation (Deep Sea Controller) 97
9.1 Main Circuit Breaker ........................................................................... 97
9.2 Genset Controller Power Switch .........................................................98
9.3 Selecting the Voltage .......................................................................... 99