Wacker Neuson G 240

Table of Contents
G 230 / G 240
wc_bo5000186930_09_FM10TOC.fm
9
9.4 Deep Sea Controller Buttons/Functions ........................................... 102
9.5 Genset Controller Alarms and Shut-Down Conditions ..................... 104
9.6 Before Starting the Machine ............................................................. 106
9.7 Starting and Running the Generator ................................................ 107
9.8 Stopping the Generator .................................................................... 109
9.9 Emergency Stop Switch ................................................................... 110
9.10 Engine and Generator Monitoring .................................................... 111
10 Working with Deep Sea Controller: DSE 7310 112
10.1 Introduction ....................................................................................... 112
10.2 Navigating the Menus ....................................................................... 113
10.3 Adjusting Screen Contrast ................................................................ 115
10.4 How to Reset the Maintenance Timer .............................................. 116
11 How to Connect Loads 117
11.1 Lug Terminal Connection Diagrams ................................................. 117
11.2 Best Practices for Balancing Loads .................................................. 118
11.3 Connecting 480V, 3-Phase and Single-Phase Loads ...................... 120
11.4 Connecting a 240V 3Ø Load and a 240V 1Ø Load .......................... 121
11.5 Connecting a 220–240V 3Ø Load and Multiple 127–133V 1Ø Loads 122
11.6 Connecting a 208V 3Ø Load and Multiple 120V 1Ø Loads .............. 123
12 Using Remote Start Capabilities 124
12.1 Remote Run Terminal Block ............................................................ 124
12.2 Remote Transfer Switch ................................................................... 125
12.3 Preparing for Automatic/Remote Start-Up (Basler) .......................... 126
12.4 Preparing for Automatic/Remote Start-Up (Deep Sea) .................... 127
13 Diagnostic Trouble Codes (DTC) 129
13.1 Accessing DTCs with the Basler Controller ...................................... 129
13.2 Accessing Engine DTCs using the Deep Sea Controller ................. 130
13.3 List of Engine Diagnostic Trouble Codes (DTCs) ............................. 131
14 Factory-Installed Options 145
14.1 Battery Charger ................................................................................ 145
14.2 Lockable Battery Disconnect ............................................................ 146
14.3 Camlocks .......................................................................................... 147