Watlow ez-zone pm - Page 164

Watlow EZ-ZONE
®
PMI Controller • 160 • Chapter 7 Profiling Page
Profiling Parameters
p1
prof Profile (1 to 4)
1
P1 Profile [1 to 4] Step (1 to 40)
s.typ Step Type
t.SP1 Target Set Point Loop 1
t.SP2 Target Set Point Loop 2
hoUr Hours
ЛЏin Minutes
SEC Seconds
ratE Rate
ФІ.pi Wait For Process Instance
ФІ.P1 Wait For Process 1
ФІ.E1 Wait For Event 1
ФІE.2 Wait for Event 2
doФІ Day of Week
Js Jump Step
JC Jump Count
End End Type
Ent1 Event 1
Ent2 Event 2
Starting a Profile from the Home Page
1. When at the Home Page, press the Advance Key ‰ to locate Prole Start and select the
le or step number to start. The upper display will show 1 and the lower display will show
p.st1.
2. Press the Up ¿ or Down ¯ key to choose the le or step number.
3. Press the Advance Key ‰ to select the Prole Action Request. The upper display will show
nonE and the lower display will show p.aC1.
4. Press the Up ¿ or Down ¯ keys to select the Prole Start. The upper display will show
prof and the lower display will show p.aC1.
5. Press the Innity Key to return Home. The Prole will Start
Ending a Profile from the Home Page
1. Press the Advance Key ‰ to select the Prole Action Request. The upper display will show
nonE and the lower display will show p.AC!.
2. Press the Up ¿ or Down ¯ keys to select the End. The upper display will show End and
the lower display will show p.aC1.
3. Press the Innity Key to return Home. The Prole will End.