Watlow ez-zone pm - Page 163

Watlow EZ-ZONE
®
PMI Controller • 159 • Chapter 7 Profiling Page
3. Press the Advance Key ‰ to enter this menu. The upper display will show 1 and the lower
display will show p.str.
4. Press the Up ¿ or Down ¯ keys to select the Prole or Step to start. In this example se-
lect 1.
5. Press the Advance Key ‰ to select the Prole Action Request. The upper display will show
nonE and the lower display will show p.aCr.
6. Press the Up ¿ or Down ¯ keys to select the Prole start. The upper display will show
prof and the lower display will show p.aCr.
Note:
As soon as the Green Advance Key ‰ is pressed (step 7 below) the designated Profile or
Step (as determined in step 4 above) will start.
7. Press the Advance Key ‰ to select whether Event 1 will be on or off. The upper display
will show off and the lower display will show Ent1.
Note:
This setting will temporally override the profile configuration.
8. Press the Up ¿ or Down ¯ keys to select whether Event 1 will be on or off. This will im-
mediately drive the Event to the specied state regardless of the Prole conguration.
9. Press the Advance Key ‰ to select whether Event 2 will be on or off. The upper display
will show off and the lower display will show Ent2.
10. Press the Up ¿ or Down ¯ keys to select whether Event 2 will be on or off. This will im-
mediately drive the Event to the specied state regardless of the Prole conguration.
Note:
The event state will be as left when the profile ended and may be toggled at the profile
status menu.
11. Press the Advance Key ‰ to see the current Jump Count. The upper display will show 0
and the lower display will show JC.
12. Return to the Home Page by pressing and holding the Innity Key ˆ for approximately
three seconds.
Ending a Profile from the Operations Page
1. Navigate to the Operations Page and then the Prole Status menu. From the Home Page,
press and hold the ¿ or Down ¯ key for approximately three seconds where the upper
display will show ai and the lower display will show opEr.
2. Press the Up ¿ or Down ¯ key to navigate to the Prole Status p.sta menu.
3. Press the Advance Key ‰ to enter this menu. The upper display will show 1 and the lower
display will show p.str.
4. Press the Advance Key ‰ to select the Prole Action Request. The upper display will show
nonE and the lower display will show p.aCr.
6. Press the Up ¿ or Down ¯ keys to select the End. The upper display will show End and
the lower display will show P.aCr.
7. Press the Advance Key ‰ to end the Prole.
8. Return to the Home Page by pressing and holding the Innity Key ˆ for approximately
three seconds.