Brightness: picture brightness.
Saturation: brilliance of the picture color.
Sharpness: picture clarity.
Contrast: picture transparency.
Operation Steps
Step 1 Click a camera in the camera list on the left side of the Picture Parameter screen.
Step 2 Select where to install this camera from the drop-down list. The default values of
picture parameters vary with scenarios.
Step 3 Set the camera brightness, contrast, saturation, and sharpness.
Step 4 Click OK to save picture parameter settings or click Copy to all, then click OK to
apply the parameter settings to cameras of all channels.
----End
5.3 Encode Parameter
The system allows you to set the main video resolution, sub video resolution, and
image quality (low-quality, medium-quality, high-quality, or best-quality) for cameras
in a channel, and view the frame rate and stream size in Encode Parameter.
Operation Description
Click Menu in the upper left corner of the camera management screen and choose
Encode Param to access the Encode Parameter screen, as shown in Figure 5-4.
To Next Page
Loading...
