Figure 6-5 DST setting screen
Step 2 Click next to Daylight saving time to enable DST.
Step 3 Select start time, end time, offset time from the drop-down list respectively.
Step 4 Click OK to save settings or click Cancel to cancel settings.
----End
6.2 Network
6.2.1 Ipv4
IPv4 is the IP protocol that uses an address length of 32 bits.
Operation Steps
Step 1 On the System setting screen, choose Network > IPv4 to access the Ipv4 setting
screen, as shown in Figure 6-6.
To Next Page
Loading...
