Figure 9-10 IPv4 interface
Step 2 Click next to Obtain IP automatically to enable or disable the function of
automatically getting an IP address. The function is enabled by default.
If the function is disabled, click input boxes next to IP, Netmask, and Gateway to set
the parameters as required.
Step 3 Click next to Obtain DNS Automatically to enable or disable the function of
automatically getting a DNS address. The function is enabled by default.
If the function is disabled, click input boxes next to DNS1 and DNS2, delete original
addresses, and enter new addresses.
Step 4 Click Apply to save the settings.
----End
9.5.2.2 Port
Operation Steps
Step 1 Click PORT label to enter the port setting interface, as shown in Figure 9-11
To Next Page
Loading...
