Commissioning
6.5 Commissioning the vehicle
100
Operator’s Manual | 4080T Basic Line | 1000408123 | 05/2019 | [en]
Coding new starting keys
New personal starting keys can be coded with the red master key. Store
the red master key carefully and separately from the vehicle. Up to ten
blue starting keys can be coded.
The drive interlock has only one master key. If the master key is lost, the
complete drive interlock must be replaced by an authorized service cen-
ter.
The master key can only be used to code new starting keys. The drive in-
terlock cannot be deactivated with the master key.
ü Blue starting keys and master keys to be coded are available.
ü Switch on the parking light to code new blue starting keys.
1. Insert the master key into the ignition lock.
2. Switch ignition to position I for a maximum of five seconds.
3. Switch ignition to position 0 and remove master key.
ð The electronics system expects a starting key to be coded within
the next 15 seconds.
4. Insert the starting key and switch the ignition to position I for at least
one second.
ð New starting key is coded.
If several starting keys are to be coded, the starting keys to be coded can
be coded one after the other without having to reinsert the master key
into the ignition lock. However, no more than 15 seconds must elapse
between the removal of the master key or the starting key that has been
coded and the next starting key to be coded. Repeat the procedure from
step I if more than 15 seconds have elapsed.
Store the master key outside the cab to avoid incorrect information from
the electronics system, e.g. the signal from the master key and an addi-
tional signal from a coded starting key.
Enabling the drive interlock
Always remove the starting key when the drive interlock is to be switched
on. If the starting key is left inserted, the drive interlock is not activated.
1. Apply the parking brake.
2. Switch off engine, move ignition to position 0.
3. Remove the starting key.
ð The drive interlock is activated after 30 seconds.
Disabling the drive interlock
1. Insert the starting key in the ignition lock.
ð The drive interlock is deactivated after five seconds.
2. Start the engine.
ð The drive interlock is permanently deactivated when the engine is
running.
To Next Page
Loading...
