Commissioning
Commissioning the vehicle 6.5
101
[en] | 05/2019 | 1000408123 | 4080T Basic Line | Operator’s Manual
Deleting coded keys
If a coded blue starting key is lost, all other coded keys must also be de-
leted. The master key code is not deleted during the deletion process.
After the deletion process, the remaining stating keys can be coded
anew.
1. Switch on the parking lights.
2. Insert the master key into the ignition lock.
3. Switch ignition to position I for at least 20 seconds.
ð Coding for the blue starting key is deleted.
ð Blue starting keys can be recoded.
6.5.5
Do not operate the engine at low load
Running performance can be negatively affected if the vehicle is operated
at high engine speed and at less than 20% of the load. Possible con-
sequences of low-load operation:
• Operating temperature is too low.
• Lube-oil consumption rises.
• Engine contamination due to lubricating oil in exhaust system.
– This contamination is recognizable by bluish exhaust gases; lub-
ricating oil is burnt.
Operate the engine at a load greater than 20 %.
6.5.6
Stopping the engine
NOTICE
Damages to the engine!
If the engine is switched off directly from full load operation, the engine
may be damaged due to an excessively high operating temperature.
► Allow the engine to idle for approx. three minutes.
► Then switch off the engine.
NOTICE
Immediate starting of the engine after shutdown can cause damage
to the starting motor.
► Wait approx. 15 seconds before restarting the engine.
6
To Next Page
Loading...
