Weidemann Basic line 4080T - Page 117

Operation
Operating the lighting and signal system 7.5
117
[en] | 05/2019 | 1000408123 | 4080T Basic Line | Operator’s Manual
7.5.2
Changing over between low and high beam
1
Fig.94: Low beam and high beam
▪ Move the steering column switch upwards until it resists and hold it.
ð The headlight flasher illuminates.
▪ Release the steering column switch.
ð Headlight flasher is off.
▪ Move the steering column switch beyond the resistance downward.
ð Control light
illuminates.
ð High beam is switched on.
▪ Move the steering column switch beyond the resistance upward.
ð The control light
goes out.
ð Low beam is switched on.
7.5.3
Operating the turn signal
I
II
Fig.95: Operating the turn signal
▪ Move the steering column switch into positionI.
ð The control light
flashes.
ð Turn signal on the right flashes.
▪ Move the steering column switch into positionII.
ð The control light
flashes.
ð Turn signal on the left flashes.
7.5.4
Operating the horn
Fig.96: Operating the horn
The horn is operated with steering column switch.
1. Press the switch on the steering column switch.
ð The horn sounds.
2. Release the switch on the steering column switch.
ð The horn no longer sounds.
7