Operation
Working with the vehicle 7.8
131
[en] | 05/2019 | 1000408123 | 4080T Basic Line | Operator’s Manual
Permitted attachments
NOTICE
Damage caused by non-approved attachments.
To avoid damage to the vehicle, only the attachments listed in the
chapter "Attachments for the vehicle" are permitted.
► For the installation of attachments which are not listed there, ap-
proval must be obtained from the manufacturer of the vehicle and an
EBE (individual type approval) from the competent authorities is re-
quired.
Only attachments approved by the vehicle manufacturer may be used.
The vehicle manufacturer accepts no liability for the use of non-approved
attachments.
Avoid overloading the vehicle. Do not use excessively large buckets for
heavy loads.
If new hydraulic hose lines have to be laid for an attachment, contact an
authorized service center. Only an authorized service center is allowed to
install new hydraulic hoses.
Coupling attachments
WARNING
Accident hazard due to persons in the danger zone!
Persons who are in the danger zone of the vehicle or suddenly enter it
can be injured by working movement or the moving vehicle. This may
result in accidents that could result in serious injury or death.
► Interrupt work immediately if persons enter the danger zone.
► Adjust the mirror correctly. Use visual aids such as, e.g. a camera.
► Observe extreme caution when reversing.
WARNING
Risk of accident due to unintentional release of the attachment lock!
The locking of incorrectly locked attachments can disengage unintention-
ally. This may result in accidents that could result in serious injury or
death.
► Always check for correct locking after attaching attachments.
7
To Next Page
Loading...
