Malfunctions
10.2 Fault indications on the display
230
Operator’s Manual | 4080T Basic Line | 1000408123 | 05/2019 | [en]
Fig.216: Error codes in the display
If the vehicle electronics issues an error, an error code is displayed in the
indicating instrument. Note down the error code before stopping the en-
gine. Some error codes no longer appear after the ignition is switched off,
although the error may still exist. If an error code that is not listed in the
table appears, contact an authorized service center.
SPN code Error description Measures to be taken
0097 Water in fuel Water separator maintenance
0100 Oil pressure too low or too high Stop the engine immediately
Check engine oil level, add en-
gine oil if necessary
0107 Dirty air filter Clean the air filter
0110 Cooling temperature too high Stop the engine
Check the radiator
5319 Incomplete regeneration of the diesel particulate filter Starting manual regeneration
Take the vehicle to a service
center
To Next Page
Loading...
