Malfunctions
Fault indications on the display 10.2
229
[en] | 05/2019 | 1000408123 | 4080T Basic Line | Operator’s Manual
Fig.215: Error messages in the dis-
play with symbol
Error messages with symbol
Dirt accumulation on air filter
The symbol appears when the air filter contamination
level is too high.
Clean the air filter and replace it if necessary.
Temperature of coolant too high
The symbol appears if the temperature of the coolant is
too high.
1) Stop the engine.
2) Allow the vehicle to cool down.
3) Clean radiator if necessary.
Water in fuel
The symbol appears if too much water has accumulated
in the water separator on the fuel filter.
Drain water in the water separator.
Temperature of hydraulic oil too high
The symbol appears when the maximum permissible
temperature of the hydraulic oil has been reached.
Switch off the engine and let the hydraulic oil cool down.
Determine the cause of the fault and eliminate it, e.g.
clean the radiator.
If the error still occurs, contact an authorized service
center.
Return filter from hydraulic oil
The symbol appears when the resistance of the oil flow
in the return filter becomes too high.
Switch off the engine and have the return filter changed
by an authorized service center.
10.2.1.1
Error codes
NOTICE
Technical damage due to failure to observe the error code! Failure
to observe the error codes can cause serious technical damage!
In case of a malfunction during vehicle operation, the operating hours and
engine speed readout is replaced by an error code.
► Proceed as specified in the error code table.
► Get in touch with a service center if the error persists in spite of pro-
ceeding as specified.
► Make a note of error codes that are not listed and inform the service
center of them.
10
To Next Page
Loading...
