Commissioning
Setting up the operator station 6.2
85
[en] | 05/2019 | 1000408123 | 4080T Basic Line | Operator’s Manual
NOTICE
Damage to the compressor.
Too long operation of the suspension adjustment can cause damage to
the compressor.
► Do not operate the suspension adjustment for more than one minute.
The individually desired height can be adjusted up to a minimum spring
travel.
ü The ignition must be switched on.
1. Pull lever 10 upward.
ð The seat moves upwards and the suspension travel increases.
2. Push lever 10 down.
ð The seat moves downwards, the suspension travel becomes
smaller.
3. Release lever 10 when the seat has reached the desired position.
ð Suspension and height are adjusted.
6.2.2
Seat belt
WARNING
Injury hazard if the seat belt is not fastened correctly or not at all!
Fastening the seat belt incorrectly, or not at all, can cause serious injury
or death.
► Fasten the seat belt before operation.
► Do not fasten a twisted seat belt.
► Do not place the seat belt over hard, edged or fragile items in your
clothes.
► Firmly fasten your seat belt over your hips.
WARNING
Risk of injury due to damaged or contaminated seat belt
A damaged or dirty seat belt can cause serious injury or death.
► Keep the seat belt and buckle clean.
► Check the seat belt and buckle for damage.
► Have a damaged seat belt and buckle immediately replaced by an
authorized service center.
► Have the seat belt replaced by an authorized service center after an
accident, even if there is no visible damage. Have the seat fastening
and anchoring points checked for further load-bearing capacity.
6
To Next Page
Loading...
